We use Cookies to improve your website experience. Learn about our cookie policy.

Accept

Skip to Content
Flexco
Main Content

FXC™ Steel Cord Belt Fastening System

  • FXC Splice
  • FXC Hero Image
  • FXC Field Install
  • FXC In Field Australia
  • FXC With Cover

FXC™ STEEL CORD BELT FASTENING Applications

Temporary Splice

The FXC™ can be installed quickly when there is a splice failure or significant belt damage so the operation can get back up and running until a vulcanized splice is installed. This installation takes approximately five hours with four workers on a 72 in. (1800mm) wide belt. 

Belt Pull

The FXC™ can be used to pull a belt onto the conveyor system quickly and efficiently. Belt pull kits use the same components as a temporary splice but quantities may be reduced depending on belt pull tension requirements. This installation takes approximately three hours with four workers on a 72 in. (1800mm) wide belt.

  • Products
  • Specifications
  • Instructions
  • Sales Support
Apply FiltersClose
Steel Cord Belt "ST" Rating Cord Diameter Range Cord Pitch Range Minimum Belt Thickness Splice Thickness Hinge Pin Diameter
Up to ST2500 2.5mm to 7.7mm 11mm to 23mm Temporary Splice: Restrictions* Belt Pull: No Restrictions** 25.4mm or 31.4mm*** 13mm or 19mm

Temporary splices must be covered with a self leveling liquid urethane to prevent material sifting when in operation. Cover material available from Flexco upon request.                    
                    
*Temporary Splice Note: For belts thinner than the splice, grade the cover material for a smooth transition from belt to splice. Reduce cleaner tension/drop the cleaner in cases where the belt thickness exceeds the splice thickness in Column E.                    
**Belt Pull Note: This splice does not require covering and should not be conveying material. Therefore belt thickness is not a restriction.                    
***Cord pitch greater than 20mm or cord diameter greater than 6.8mm requires 31.4mm splice thickness.                     
Contact Flexco for details.                    
 

410 Stainless was selected due to its durability and strength, as well as its corrosion resistance and formability.